NOT relocate audio and/or video equipment to the cart! corresponding instructions. The MFC Series cart has no user serviceable parts. NOTE: The MFC Series cart can support screen sizes up to a NOTE: maximum of 55" wide. IMPORTANT SAFETY INSTRUCTIONS...
Page 3
MFC Series Installation Instructions DIMENSIONS...
Installation Instructions MFC Series LEGEND Tighten Fastener Pencil Mark Apretar elemento de fijación Marcar con lápiz Befestigungsteil festziehen Stiftmarkierung Apertar fixador Marcar com lápis Serrare il fissaggio Segno a matita Bevestiging vastdraaien Potloodmerkteken Serrez les fixations Marquage au crayon Loosen Fastener Drill Hole Aflojar elemento de fijación...
MFC Series Installation Instructions TOOLS REQUIRED FOR INSTALLATION 3/16" (Included) PARTS A (1) [left leg] E (1) D (4) [center post] [snap-on cover] B (1) [right leg] C (2) [end cap] H (1) F (1) 3/16" [cross bracket] [drill bit]...
Page 6
MFC Series Installation Instructions ASSEMBLY inner column Attachment holes may be damaged if a power CAUTION: drill is used to insert button head cap screws. Screws should first be inserted and turned BY HAND with the hex key or with a hand held screwdriver BEFORE using the hex head drill bit (J) and power drill to complete the attachment.
Page 7
Installation Instructions MFC Series IMPORTANT ! : When attaching head assembly ensure that the ClickConnect lock is at TOP of head assembly, and bracket tabs slide into the cart assembly. (See Figure 5) Slide head assembly (G) into the cart assembly. (See...
Page 8
MFC Series cart up to (and including) the display does not exceed 125 lbs Lower display into place listening for audible "click" to ensure recessed area of mounting buttons are properly (56.70 kg) for the MFC Series.
Installation Instructions MFC Series Tilting Display (Rear The display can be tilted up to 15 either backward or forward view of (Front view from a straight upright position. of center post) center post) Turn knob counterclockwise on back of head assembly to loosen the tilt.
Page 10
Installation Instructions The MFC Series cart has no user serviceable parts. Cart Use and Maintenance NOTE: The MFC Series cart can support screen sizes up to a NOTE: maximum of 55" wide. Exceeding the weight capacity can result in WARNING: serious personal injury or damage to equipment! It is the Always place cart on level surface.
Page 11
Installation Instructions MFC Series Removing Display from Cart Remove bolt or padlock from faceplate (if used). (See Figure 15) The pin may have been used as a more permanent NOTE: locking device. If so, remove nut and pin and move from the lower holes to the upper holes.
Page 12
P 800.582.6480 / 952.225.6000 F 877.894.6918 / 952.894.6918 A Franklinstraat 14, 6003 DK Weert, Netherlands Europe Chief, a products division of P +31 (0) 495 580 852 Milestone AV Technologies F +31 (0) 495 580 845 A Office No. 918 on 9/F, Shatin Galleria...