CHIEF MFC Series Installation Instructions Manual page 7

Installation Instructions
IMPORTANT ! : When attaching head assembly ensure
that the ClickConnect lock is at TOP of head assembly, and
bracket tabs slide into the cart assembly. (See Figure 5)
1. Slide head assembly (G) into the cart assembly. (See
Figure 5)
2. Attach head assembly (G) to the cart assembly using four
5/16-18 x 3/4" button head cap screws (K). (See Figure 5)
ClickConnect
lock at TOP of
head assembly
Bracket Tabs
Figure 5
Adjusting Cart Height
ALWAYS remove the display(s) BEFORE
CAUTION:
adjusting the height of cart.
1. Firmly grasp head assembly. (See Figure 6)
IMPORTANT ! : To avoid pinching hands, hold head
assembly when adjusting cart height.
(K) x 4
2
(G)
2.
3.
1
IMPORTANT ! : Set the height of the cart so the display
does NOT rest on the lower part of the center post.
(See Figure 7) Always set the height so the knob is
engaged in a hole in the center post.
Grasp head assembly
within shaded area.
Figure 6
Adjust the cart to the desired height by slightly lifting the
head assembly, pulling out knob on the center post and
o
turning 90 in either direction to disengage the locking
mechanism. (See Figure 7)
Raise or lower the center post, then turn the knob 90
direction to engage the knob and lock the cart at desired
height. (See Figure 7)
Do NOT let
display rest
here
2
Figure 7
MFC Series
o
either
Inner
Column
3
7