CHIEF MFC Series Installation Instructions Manual page 6

MFC Series
ASSEMBLY
Attachment holes may be damaged if a power
CAUTION:
drill is used to insert button head cap screws. Screws should
first be inserted and turned BY HAND with the hex key or with
a hand held screwdriver BEFORE using the hex head drill bit
(J) and power drill to complete the attachment.
Assembling Cart
1. Assemble two legs (A) and (B) to the cart cross bracket (F)
using two 5/16-18 x 4-1/4" button head cap screws (M)
through one end cap (C) per leg. (See Figure 1)
(A)
(F)
(B)
(Front view of cart)
Figure 1
INNER AND OUTER COLUMNS ARE
CAUTION:
SHIPPED TAPED TOGETHER. After tape is removed the
inner column will be disengaged and may pinch hands!
• Remove tape while CAREFULLY holding both
inner and outer columns in place.
IMPORTANT ! : Press cable tie tab to loosen and
remove cable tie from around knob post. (See Figure 2)
Disengage knob on center post BEFORE attaching
NOTE:
base to the center post.
2. Lift up slightly on the inner column of center post and hold
firmly toward top of post. (See Figure 2)
3. Pull out knob on the center post and turn 90° in either
direction to disengage the locking mechanism.
Figure 2)
4. Raise the inner column and turn the knob 90° in either
direction to engage the knob and lock the column in place.
(See Figure 2)
6
(M) x 4
NOTE:
(C) x 2
5. Attach center post (E) to leg assembly using four
5/16-18 x 2-3/4" button head cap screws (L) and four 5/16"
washers (N). (See Figure 3) and (See Figure 4)
(Front view of cart)
(See
Installation Instructions
Cable
Tie
Figure 2
Insert and turn screws in order shown (1, 2, 3, 4) in
Figure 3.
1
4
3
2
(Bottom view of cart)
Figure 3
(L) x 4
Figure 4
inner column
(E)
(N) x 4