Table of Contents
Advertisement
Starting and driving
7 "Faults during Driving". If it still
cannot be started (READY status),
please contact a Farizon Auto after-
sales service station for maintenance.
Driving precautions
Vehicle driving operation
1.
Start the vehicle, depress and hold the
brake pedal, turn the gear knob to D
position, and "D" will be displayed on
the instrument cluster.
Before gear shifting, the vehicle
needs to be in READY status and
confirm that the "READY" indicator
on the instrument cluster is on.
When the gearshift operation is
wrong, the instrument cluster gear
display icon will flash 3 times with 1
prompt tone.
2.
Loosen the hand brake.
3.
Release the brake pedal and the
vehicle starts to creep; gently press the
accelerator pedal, and the vehicle
starts to run.
4.
For
acceleration,
accelerator pedal gradually; for driving
at
a
constant
accelerator pedal at a certain opening.
5.
For braking, depress the brake pedal.
6.
For reversing, depress the brake pedal
until the vehicle stops steadily and
keep it still. Turn the gear knob to R
position, and "R" will be displayed on
the instrument cluster. Release the
brake pedal and gently depress the
accelerator pedal to start reversing.
step
on
the
speed,
keep
the
Do not step on the accelerator pedal
during shifting to avoid losing control
of the vehicle.
Do not depress the brake pedal and
accelerator
when driving.
Emergency
avoided while the vehicle is running.
The vehicle shall slow down as much
as possible during turning, and
turning sharply is prohibited. Before
turning, attention shall be paid to
whether there are other vehicles or
pedestrians on the left rear and right
rear sides. Slow down to avoid other
vehicles
emergency acceleration is prohibited
during turning.
When the vehicle is in READY status
and the gearshift lever is at D
position, be sure to depress the
brake
pedal
handbrake; otherwise, the vehicle will
creep. If you leave the vehicle, be
sure to apply the parking brake and
shift to N position.
Running-in of new vehicle
Running-in of new vehicles is performed
mainly to improve the surface quality and
friction and wear status of moving parts,
extend the service life and save power
consumption. After purchasing a new
vehicle,
please
according to the following requirements.
The running-in period is measured in 5,000
km. Please follow the simple instructions
below during initial use:
86
pedal
simultaneously
braking
should
or
pedestrians,
or
pull
up
carry
out
running-in
be
and
the
Advertisement
Table of Contents
