Table of Contents
Advertisement
Repair and Maintenance
wear between the brake lining and
brake drum. The new brake lining
does not have the best friction
characteristics within the first 200 km
to 300 km, so it must be run-in. At
this
stage,
decreases
slightly,
compensated
pedal force of the brake pedal. After
replacement, running-in also needs
to be carried out for the new brake
lining
according
requirement. Do not drive too close
to
other
vehicles
emergency braking. Be especially
careful when driving with new tires
and new brake pads, so as to avoid
the above situations and accidents.
Brake pedal travel
If the brake pedal cannot be restored to
normal height or its stroke is too large,
please contact a Farizon Auto after-sales
service station for maintenance as soon as
possible. This may be a signal that the
brake system needs maintenance.
Brake squeal
When the brake pedal is depressed, the
front and rear brakes work at the same
time. If there is occasional squeal sound
during braking, it is a normal phenomenon
caused by wet or cold road surface, rainy
and
snowy
weather
environmental factors. Especially in rainy
and snowy days, it has a high probability of
occurring at low temperature, low speed
and the moment when braking is about to
stop. This is an unavoidable normal
the
braking
effect
and
can
be
by
increasing
the
to
the
above
or
perform
and
other
phenomenon and will not affect the
reliability of brake system. If there is
continuous squeal sound during braking, it
may be that the brake pad has been worn
to the limit. Please contact a Farizon Auto
after-sales service station for maintenance.
Brake creeping sound during
starting
It is normal that the brake creeping sound
occurs during starting, and friction noise
between the brake lining and the brake
drum can be heard when the brake is
released. Before starting, the electronic
gear selector is turned to forward gear (D),
and the power output pulls the vehicle to
start moving forward. At this time, under
the action of the brake, the vehicle remains
stationary, and the braking torque is
greater than the starting torque at this
time.
In
this
accumulated at the brake. When the brake
pedal is released, the energy accumulated
at the brake is released, exciting a "creak"
sound at the front wheels. The sound will
be more obvious if the brake is stained
with water after vehicle washing.
Sound of depressing the brake
pedal in situ
When the vehicle is stationary, the wheels
are rolling while turning the steering wheel.
If the brake pedal is depressed at this time,
the wheels will be prevented from rolling.
Under the simultaneous action of steering
force and braking force, the vehicle
accumulates some energy, so that the
brake lining and brake drum creep when
they are clamped to release this part of
132
process,
energy
is
Advertisement
Table of Contents
