Jump Start; Vehicle Jump Start - Geely V6E 2023 Manual

Table of Contents

Advertisement

Troubles in driving

Jump start

Vehicle jump start

If the low-voltage battery is exhausted, try
to start your vehicle with another vehicle
and jumper cable. Be sure to follow the
following steps to ensure safety.
Operation sequence for jump start of
two vehicles:
1.
Turn off the Start switch (in LOCK/OFF
position), and turn off all lamps and
electrical accessories of both vehicles,
except for hazard warning lamps (if
necessary).
2.
Open the driver's seat. Open the
positive protective cover and connect
the positive clip of jumper cable to the
positive pole (+) of battery on this
vehicle.
3.
Connect the clip at the other end of the
positive terminal of jumper cable to the
positive (+) terminal of power supply
vehicle battery.
4.
Connect the negative clip of jumper
cable to the negative pole (-) of power
supply vehicle battery.
5.
Connect the clip at the other end of the
jumper cable negative terminal to the
battery negative terminal (-) of this
vehicle.
6.
Connect the battery connection clip
firmly, and try to start the vehicle with
dead battery. If the vehicle cannot
enter READY mode, it is likely that
there will be a fault and need to be
repaired. Please contact a Farizon Auto
after-sales
maintenance.
If the jumper cables are connected
or removed in the wrong order, an
electrical short circuit may occur and
the vehicle may be damaged. The
resulting repairs are not covered by
the
warranty.
necessary to connect or disassemble
the jumper cables in the correct
order, and ensure that the cables do
not touch each other or other
metals.
Operation sequence for disconnecting
jumper cables of two vehicles:
1.
Disconnect the black negative (D) cable
on the vehicle with a dead low-voltage
battery.
2.
Disconnect the black negative (C) cable
on the vehicle with a low-voltage
battery with electricity.
3.
Disconnect the red positive (B) cable on
the vehicle with a low-voltage battery
with electricity.
4.
Disconnect the red positive (A) cable on
vehicles
with
battery.
The rated voltage of the power
supply battery during jump starting
shall be 12V, and its capacity shall
108
service
station
Therefore,
it
a
dead
low-voltage
for
is

Advertisement

Table of Contents
loading

Table of Contents