Setting The Light Barrier (Lightbarrier) Parameter - Duerkopp Adler 867-M PREMIUM Operating Instructions Manual

Programming
Operating Instructions 867-M PREMIUM - 02.0 - 05/2017
5.4.14 Setting the light barrier (LightBarrier)
parameter
The light barrier detects the beginning and the end of the material.
After a signal was detected, sewing can continue automatically
with the specifically set parameters.
Menu item
LightBarrier,
Light barrier
Start,
Signal detection at the
beginning of the material
End,
Signal detection at the end of
the material
Distance,
Distance from signal
detection to end of material
Seams,
Number of signal detections
Filter,
Filter stitches up to signal
detection
Setting: Signal detection at the beginning of the material
(Start)
The signal scan of the light barrier is performed at the beginning
of the seam. If the function is activated, the light barrier must detect
a signal to allow the machine to sew. If the function is inactive,
sewing can take place without signal detection.
Setting: Signal detection at the end of the material (End)
The signal scan of the light barrier is performed at the end of the
seam. If the function is active, the machine will continue to sew
with the specifically set parameters following the signal detection.
If the function is inactive, nothing will happen.
Setting option
ON = on
OFF = off
ON/OFF
ON/OFF
Value range 0 – 255
Value range 1 – 255
Value range 0 – 255
85