Table of Contents
Advertisement
70
(Last Repet.)
The last section of the bartack can be programmed with a different
number of stitches. All previous sections have the preset number
of stitches from the settings for the end bartack.
This function is useful for the short stitch for the short thread cutter,
for example. In this case, one less stitch is sewn in the last section.
5.4.8
Setting the Sewing foot lift parameter (Foot)
The sewing foot lift can have various settings. Possible settings
and the corresponding value ranges are listed in the table.
Menu item
FL AtStop,
Sewing foot lift when
sewing stops
FL AfterTrim,
Sewing foot lift after
thread cutting
FL ht.AtStop,
High sewing foot lift when
sewing stops
FL ht.A.Trim,
High sewing foot lift after
thread cutting
5.4.9
Setting the Bobbin monitor parameter (Bobbin)
The amount of remaining thread on the bobbin can be monitored
optically or by software using this setting.
Information
The bobbin monitor setting is global and NOT limited to an oper-
ating mode or a seam program.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Operating Instructions 867-M PREMIUM - 02.0 - 05/2017
Setting option
ON = on
OFF = off
ON = on
OFF = off
Value range 00 – 20 [mm]
(depending on subclass)
Value range 00 – 20 [mm]
(depending on subclass)
Programming
Advertisement
Table of Contents
