Table of Contents
Advertisement
Programming
Operating Instructions 867-M PREMIUM - 02.0 - 05/2017
Setting: Number of sections in a bartack (Repetitions)
A bartack always consists of several sections. If the sewing direc-
tion is changed, a new section is started. The number of sections
in a bartack can be set in this submenu.
Setting: Waiting time at turning point (t Change)
The waiting time at the turning points (for example for a change
of sewing direction) is set at this point. A short waiting time in
milliseconds should ensure consistent seam quality (ornamental-
stitch bartack).
Setting: Default stitch length (St.Len.Def.)
If this function is active, the same stitch length is used for the
bartack as the one set in Manual mode. If this function is deacti-
vated, a custom input can be entered.
Setting: Single stitches per pedal (Pedal Stop)
If this function is activated, each stitch in the bartack can be sewn
individually by pressing the pedal. This function can only be used
meaningfully if the speed is set very low for the bartack.
Setting: Default needle thread tension (Thr.Tens.Def.)
If this function is active, the same needle thread tension is used
for the bartack as the one set in Manual mode. If this function is
deactivated, a custom input can be entered.
Setting: Bartack before the bartack (Catch Backtack)
To ensure a safe sewing start and complete sewing of the start
bartack, an additional bartack can precede the start bartack.
Only the number of forward and backward stitches can be select-
ed. The stitch length cannot be set individually – it corresponds
to the stitch length of the normal start bartack.
Setting: Number of stitches different for 1
st
section
67
Advertisement
Table of Contents
