Troubleshooting - LawnMaster MEB1116K Operator's Manual

TROUBLESHOOTING

Suspected malfunctions are often due to causes that the user can fix themselves.
Therefore check the product using this section. In most cases the problem can be solved quickly.
WARNING
Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed by an authorized service center
or a similarly qualified specialist if you cannot solve the problem yourself!
Problem
Mower fails to start.
Mower cuts unevenly.
Mower does not mulch
properly
Possible Cause
The carriage bolts are not
seated properly.
The locking knobs are not
tightened.
The extension cord is not
connected to the mower
plug.
The extension cord is not
connected to the power
source.
Tripped circuit breaker in
the house.
The switch is defective.
Lawn is rough or uneven.
Cutting height is not set
properly.
Dull blade.
Wet grass clippings
sticking to the underside of
the deck.
26
Solution
Adjust the height of the handle and
make sure the carriage bolts are seated
properly.
Tighten locking knobs.
Reconnect the cord and use the cord
retainer to keep the cord close to the
motor/blade control.
Connect the extension cord to a live 120
V AC, 60 HZ AC receptacle.
Reset house circuit breaker. If it trips
again, call a qualified electrician.
Replace the switch or contact sales@
cleva.com.cn for assistance
Check the mowing area.
Set the mower at a higher position.
Sharpen or replace the blade.
Wait until the grass dries before mowing.