Table of Contents
Advertisement
TROUBLESHOOTING
WARNING
Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed by an authorized service center
PROBLEM
Rough or uneven lawn.
Mower cuts unevenly.
Cutting height not set properly.
The blade is dull.
High grass or low cutting
height makes rear wheels
and blades trapped in heavy
grass.
Mower is hard to
push.
The blades are jammed.
The cutting blades are not
assembled securely.
Mower makes
The blades are not balanced.
abnormal noise.
The blade is dull.
Lawn turns yellow, cut
not clean.
Cutting height is too low.
Mower leaves deep
Ground is softened by water.
tracks.
Lawn is too wet.
POSSIBLE CAUSE
15
SOLUTION
Check the mowing area.
Set the mower at a higher position.
Sharpen the blades.
Raise the cutting height.
Check for grass and debris under the
mower cover, clean to make blades free
to move.
Tighten the blade bolts properly.
Sharpen and balance the blades
following instructions in this manual (see
page 13).
Sharpen the blades.
Use a slightly higher cutting height.
Allow lawn to dry. Do not mow if grass is
wet.
Advertisement
Table of Contents
