Table of Contents
Advertisement
Dimmer Curve
To set the dimmer curve, follow the instructions below:
1. Go to the Dimmer Curve main level.
2. Select the desired option (Linear, Square, I Squa, or SCurve).
3. Press <ENTER>.
Master/Slave
The Master/Slave mode allows a group of Ovation E-910FC IP products (the slaves) to simultaneously
duplicate the output of another Ovation E-910FC IP (the master) without a DMX controller.
To set each of the slaves:
1. Go to the Master/Slave main level
2. Select Slave.
To set the master:
1. Go to the Master/Slave main level
2. Select Master.
3. Select a static setting.
•
The master is the one that runs a program whether in Auto or Static mode.
•
Do not connect a DMX controller to the products configured for Master/Slave operation.
The DMX controller may interfere with signals from the master.
•
The master should be the first product in the daisy chain.
Dimmer Profiles
This setting determines how fast the output of the Ovation E-910FC IP changes when the output value is
modified. It provides four different options to simulate the dimming curve of an incandescent lighting product.
1. Go to the Dimmer Mode main level.
2. Select a dimmer curve (Off, Dimmer 1, Dimmer 2, or Dimmer 3).
Off: The output is proportional (linear) to the dimmer channel value.
Dimmer 1-3: The output follows the dimmer value based on the corresponding dimmer curve,
Dimmer 1 being the fastest.
White Balance
This setting determines the maximum output values for each color, which affects the appearance of a full
output white.
1. Go to the White Balance main level.
2. Select Off (the product will use a default setting) or Manual.
3. For Manual mode, select the color value to edit (Red, Green, Blue, Amber, or Lime).
4. Set the maximum value for the selected color (125–255).
5. Repeat steps 3 and 4 until the product outputs as desired.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the
Ovation E-910FC IP.
1. Go to the LED Frequency main level.
2. Select PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25Khz).
Fan Mode
This setting determines how the fan speed on the Ovation E-910FC IP is set.
1. Go to the Fan Mode main level
2. Select Auto (fan speed will increase or decrease based on product temperature), Off (fan will stay
off. Product output will decrease based on product temperature), Silent (fan will maintain a
constant silent speed), or On (fan speed will always be at maximum).
NOTICE: When operating in Fan Mode: Off, the output of the fixture will be reduced and
will not reach the same levels as when using other fan modes.
WARNING: When operating in Fan Mode: Off, the fixture will become hotter to the touch
than when using other fan modes. Use proper protective equipment to prevent burns.
Keep a safe distance from flammable objects.
16
Ovation E-910FC IP User Manual Rev. 11
Operation
Advertisement
Table of Contents
