Table of Contents
Advertisement
Rotating the Barrel Assembly
The Ovation E-910FC IP allows manual rotation of the barrel assembly, as follows:
1. Locate the barrel rotation knobs at the top and bottom of the light engine.
2. Loosen the knobs by turning them counterclockwise. (Note: Do not remove the knobs.)
3. Rotate the barrel to the desired position, up to 25° in either direction from the centered position.
4. Tighten the knobs by turning them clockwise, which locks the barrel's position.
Ensure that the barrel assembly is oriented with the pattern holder and accessory slots at
the top of the product.
Accessory Slot
The Ovation E-910FC IP has an accessory slot, which holds a drop-in iris, a motorized pattern device, or
various other optional accessories (sold separately).
1. Loosen the thumbscrews on the slot cover. (Note: Do not remove the thumbscrews).
2. Slide to cover forward.
3. Insert an accessory. (Note: Make sure to insert the accessory correctly. i.e., the iris handle
extends upward from the slot.
4. Slide the cover back. Make sure any handles or adjustment tools that stick out the top are able to
function correctly.
5. Tighten the thumbscrews to secure the cover.
Accessory Slot Cover
•
When not using the accessory slot, replace and secure the slot cover to prevent light
leakage during operation.
•
When obtaining any optional accessories, be sure the items are compatible with the
Ovation E-910FC IP.
Soft Focus Filter
The Ovation E-910FC IP comes with a soft focus filter. To keep the soft focus filter in good condition:
•
Ensure that no fingerprints are left on the filter, as this may cause the filter to heat unevenly and
eventually warp.
•
When placing the filter in the holder, follow the orientation direction printed on the filter.
•
When inserting shutter blades into the light path, note that the heat is reflected back at the filter. The
deeper the blades are inserted, and the longer the fixture runs, the more heat gets reflected on to
the filter, causing it to warp and potentially adhere to the shutter blades.
If there is a protective film on the soft-focus filter, it must be removed before use. The filter
is in a holder in the metal gobo slot.
The lifespan and effectiveness of the Soft Focus Filter accessory included with this
product will be negatively impacted by excessive reflected heat caused by the extended
use of gobos, shutters, irises, and other beam shaping accessories. The filter is not
covered by the limited warranty. Replacements are available for purchase.
10
Thumb screws
Iris handle
Sample Drop-in Iris
Ovation E-910FC IP User Manual Rev. 11
Setup
Advertisement
Table of Contents
