Table of Contents
Advertisement
Setup
Mounting
Before mounting the product, read and follow the safety recommendations indicated in the
For the Chauvet Professional line of mounting clamps, go to http://trusst.com/products/.
Orientation
Always mount this product in a safe position, making sure there is adequate room for ventilation,
configuration, and maintenance.
Rigging
Chauvet recommends using the following general guidelines when mounting this product.
•
Before deciding on a location for the product, always make sure there is easy access to the product
for maintenance and programming.
•
Make sure that the structure and attachment points can support the weight before hanging the
product (see the
Technical
•
When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, such as an elevated platform or a truss.
•
When rigging the product onto a truss, use a mounting clamp of appropriate weight capacity.
•
The bracket adjustment knobs allow for directional adjustment when aiming the product to the
desired angle. Only loosen or tighten the bracket knobs manually. Using tools could damage the
knobs.
•
When power linking multiple products, mount the products close enough for power linking cables to
reach.
Procedure
The Ovation E-910FC IP comes with a double-bracketed yoke that can be used as a floor stand or to which
mounting clamps can be attached for hanging. Mounting clamps must be purchased separately. Ensure that
the clamps can support the weight of this product. Use at least one mounting point per product where
necessary.
Mounting Diagram
Mounting clamp
(such as CTC-50 or CTC-50HCN
from Chauvet)
Manual Beam Focus Control
The Ovation E-910FC IP has a manual focus, which is adjusted as follows:
1. Locate the beam focus knobs at the top and bottom of the barrel assembly.
2. Loosen the knobs by turning them counter-clockwise.
3. Slide the lens tube forward or backward until the desired focus or beam edge is achieved.
4. Tighten the knobs by turning them clockwise, which lock the lens tube's position.
To avoid changing menu settings while focusing the Ovation E-910FC IP, press and hold
the <ENTER> button for 3 seconds. This will put the product in Focus Mode, by increasing
the intensity to 100%. To exit out of focus mode, press <MENU>.
Ovation E-910FC IP User Manual Rev. 11
Specifications)
Safety
Notes.
Safety cable
(such as CH-05 from
Chauvet)
9
Advertisement
Table of Contents
