Table of Contents
Advertisement
Operation
Configuration (Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
Preset Color Mode
To run the COREpar Q120 ILS on a static color, follow the instructions below:
1.
Press <MENU> repeatedly until C-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select a static color, from C 1–29.
4.
Press <ENTER>.
Automatic Programs
To run the COREpar Q120 ILS in automatic mode, follow the instructions below:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select an automatic program, from P 1–4.
4.
Press <ENTER>.
Auto-Program Speed
To change the auto-program speed on the COREpar Q120 ILS , do the following:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Use <UP> or <DOWN> to increase or decrease the program speed, from S. 1–100.
3.
Press <ENTER>. The product will return to the last selected mode.
Sound-Active Programs
To run the COREpar Q120 ILS with a sound-active program, follow the instructions below.
1. Press <MENU> repeatedly until Snd shows on the display.
2. Use <UP> or <DOWN> to set the Sound-Active program, from Snd1 (4-color snap) to Snd2 (29-
color snap).
3. Press <ENTER>.
Sound Sensitivity
To set the sound sensitivity on the COREpar Q120 ILS , do the following:
1.
Press <MENU> repeatedly until SenS shows on the display.
2.
Use <UP> or <DOWN> to increase or decrease the sound sensitivity, from u 0–100.
3.
Press <ENTER>.
Custom Color Mixing
To custom mix a static color, do the following:
1.
Press <MENU> repeatedly until u-- shows on the display.
2.
Press <ENTER> and one of the following will show on display.
•
r._ _ _ (red)
•
g._ _ _ (green)
•
b._ _ _ (blue)
•
w._ _ _ (White)
3.
Press <ENTER> to cycle through the color settings.
4.
When the desired color shows on the display, use <UP> or <DOWN> to increase or decrease the
color value, from 000–255.
5.
Repeat steps 3 and 4 until the product outputs as desired.
Dimmer Curve
To set the dimmer curve, follow the instructions below:
1.
Press <MENU> repeatedly until diM shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to set the dimmer curve, from oFF to diM1–3, with diM1 as the fastest
and diM3 as the slowest.
4.
Press <ENTER>.
COREpar Q120 ILS User Manual Rev. 1
Page 11 of 17
Advertisement
Table of Contents
