Table of Contents
Advertisement
Tone configuration
Balance
Loudness
Loudness level
Tone control
Treble
Bass
This menu point is used to alter the balance in level between the left and right chan-
nels, e.g. to compensate for non-symmetrical loudspeaker positioning. The balance
can be adjusted in increments of 1 dB; the screen always displays the current value.
The PSD 3100 HV is equipped with a volume-dependent tone control (LOUDNESS) cir-
cuit, which compensates for the frequency-dependent sensitivity of the human ear at
very low volume levels, due to the characteristics of aural physiology.
This menu point is used to switch the loudness circuit on and off.
This menu point is used to adjust Loudness to suit the loudspeakers and the listening
room.
This menu point can be used to disable (by-pass) the PSD 3100 HV's tone controls.
To switch off the tone controls, select the "OFF" setting. When the tone controls are
switched off, any adjustments you make to the following menu points "BASS" and
"TREBLE" have no effect.
Under this menu item you can disable not used sources, and assign a plain text name to
each source which is in use; this name then appears in the screen displays.
If you wish to connect a device with its own volume control (e.g. TV set), this menu point
can be used to disable the volume control of the PSD 3100 HV for the Analog IN 1 input
(pass-through mode).
27
Advertisement
Table of Contents
