Connecting The Battery; Charging The Battery - Toro Reelmaster 5010-H Operator's Manual

Disconnecting the Battery (continued)
3. Remove the cover
by pressing the sides of the battery cover.
4. Disconnect the negative battery cable
5. Slide the insulator cover
battery-cable clamp, and disconnect the
positive battery cable.

Connecting the Battery

1. Install the positive battery cable (red)
positive (+) battery post.
2. Install the negative battery cable (black)
the negative (-) battery post.
3. Apply a coat of Grafo 112X (skin-over) grease,
Toro Part No. 505-47 to the battery posts and
battery-cable clamps.
4. Slide the rubber boot over the positive battery-
cable clamp.
5. Assemble the cover over the battery, inserting
the tabs
battery tray.
6. Close and latch the screen.

Charging the Battery

1. Disconnect the battery.
2. Connect a 3 to 4 A battery charger to the battery posts.
3. Charge the battery at a rate of 3 to 4 A for 4 to 8 hours.
4. When the battery is charged, disconnect the charger from the electrical outlet and
battery posts.
5. Connect the battery.
Maintenance: Electrical System Maintenance
from the battery tray
off the positive
of the cover into the slots
.
G416225
to the
to
in the
G416226
Page 6–27 3464-478 A