Lubrication; Greasing The Bearings And Bushings - Toro Reelmaster 5010-H Operator's Manual
Traction unit
Hide thumbs
Also See for Reelmaster 5010-H:
- Diagnostic manual (476 pages) ,
- Service manual (335 pages) ,
- Operator's manual (84 pages)
Table of Contents
Advertisement
Jacking Point Locations (continued)
Front of the machine
Jack brackets (front-axle tube)
Lubrication
Greasing the Bearings and Bushings
The machine has grease fittings that must be lubricated regularly. Dusty and dirty operating
conditions could cause dirt to get into the bearings and bushings, resulting in accelerated
wear. Lubricate the grease fittings immediately after every washing, regardless of the
interval specified.
1. Prepare the machine for maintenance.
2. Separate the generator cooling-air shrouds.
3. Grease all machine fittings with No. 2 lithium grease.
4. Assemble the generator cooling-air shrouds.
3464-478A
G437877
Rear-axle tube
Back of the machine
Page 6–10
Maintenance: Lubrication
Advertisement
Table of Contents
