Kemppi WFX 200 Operating Manual page 21

H REMOTE
CHANNEL
4T
2T
CH REMOTE
CHANNEL
CH REMOTE
CHANNEL
3.3.8 Extra functions button (8)
4T
2T
PANEL
XF 37
Short press: Selects Crater fill or Hot start function.
Long press: Turns MMA/CC/CV mode ON/OFF.
3.3.9 Remote Selection Button (9)
PANEL
XF 37
Short press: Toggles the control between the control panel, gun remote control unit and
hand-held remote control unit.
If RemoteAutoRecog setting is ON in X 37 control panel, you can select only those remote
NOTE!
controls, which can be found in the system.
Long press: Turns the memory channel remote selection ON/OFF. This is available only if you
have selected either gun remote control unit or hand-held remote control unit. Not available
in MMA/CC/CV mode.
3.3.10 Power control knob (10)
This control knob adjusts
• wire feed speed or power in MIG/MAG processes (before or during welding)
4T
• MMA/CC current level (before or during welding)
2T
• selected parameter values.
3.3.11 Arc length and voltage control knob (11)
This control knob adjusts the arc length, voltage or selected parameter values before or
during welding.
4T
2T
PANEL
XF 37
© Kemppi Oy / 1736
PANEL
XF 37
EN
19