Wiring Diagrams - Banner SureCross DX80N9X6S0P0M4M4 Manual

SureCross DX80 Node with Analog I/O

Wiring Diagrams

5-pin Euro-Style Hookup (Nodes)
Wiring the 5-pin Euro-style connector depends on the model and power requirements of the device.
Connecting dc power to the communication pins will cause permanent damage. For FlexPower devices, do not apply more than 5.5V to
the gray wire.
DX80...C Wiring
Wiring power to the DX80...C models varies depending the power requirements of the model.
Terminal Label Gateway, DX85 *
V+ 10 to 30V dc
Tx RS485 / D1 / B / +
V- dc common (GND)
Rx RS485 / D0 / A / -
B+
* Connecting dc power to the communication pins will cause permanent damage.
** For FlexPower devices, do not apply more than 5.5V to the gray wire.
Terminal Block (IP67 Housing)
Connecting dc power to the communication pins will cause permanent damage. Do not exceed analog input ratings for analog inputs.
Only connect sensor outputs to analog inputs.
GND GND
CM4 CM2
CM3 CM1
AO4 AI4
AO3 AI3
AO2 AI2
AO1 AI1
P/N 134322 rev. G
Wire No. Wire Color 10 to 30V dc Powered Nodes
1 Brown 10 to 30V dc
2 White
3 Blue dc common (GND)
4 Black
5 Gray
10 to 30V dc Powered Nodes
10 to 30V dc
dc common (GND)
www.bannerengineering.com - tel: 763-544-3164
AIx or Ax. Analog IN x.
AOx. Analog OUT x.
CMx. Not used. Do not make any wiring connections to these terminals.
GND. Ground/dc common connection.
PWR. Power, 10 to 30V dc power connection.
Battery Powered Nodes
dc common (GND)
3.6 to 5.5V dc
Battery Powered Nodes **
dc common (GND)
3.6 to 5.5V dc
3