Understanding The Control Board - Pit Boss PB1000R2 Assembly And Operation Manual

UNDERSTANDING THE CONTROL BOARD

MP1
FC
Actual
IGNITOR
300
250
PRIME
225
200
SMOKE
OFF HIGH
14
CONTROL
IGNITOR
Set
MP1
NO
PELLET
Actual
350
F/C
400
450
475
IGNITOR
NO
PELLET
PRIME
F/C
DESCRIPTION
The LCD Screen is used as the information center for
MP1
FC
your unit. The LCD screen will display the current grill
temperature (ACTUAL) and meat probe temperature (MP1).
See Troubleshooting for more information on error codes.
Actual Set
NO
PELLET
READOUT
Flashing
Screen
MP1
FC
Actual
Set
Set
noP
Er1
Er2
Er3
ErH
ErP
ID
Motor
Ignitor
Fan
No Pellet
Press and hold the Prime Button to activate an extra feed of
pellets to the burn pot. This can be used to add more fuel to
the fire just before opening the barrel lid, resulting in a quicker
heat recovery time. It can also be used to add more fuel while
smoking, to increase the intensity of clean smoke flavor.
Overfeeding the burn pot may damage to grill barrel paint.
The Temperature Switch Button is used to change the
temperature readout on the LCD Screen. Press the button
to switch to Fahrenheit (ºF) or to Celsius (ºC), as preferred.
Default is set to Fahrenheit.
The Temperature Control Dial allows you to set your desired
temperature. Rotate the knob marker to select from Smoke,
any of the eight temperature presets, or High. Once rotating
the dial, the SET Temperature on the LCD Screen will adjust.
DESCRIPTION
Indicates the unit was just connected to
AC power. Screen flashes three times, then
turns off.
Indicates the meat probe temperature
when probe is connected.
Indicates the current temperature of unit.
Indicates the desired temperature that has
been selected.
Indicated that no meat probe is connected.
Grill Probe wire not connecting.
Failure to reach minimum temperature of
130F during start-up cycle.
Fire has gone out due to lack of fuel.
Grill has overheated.
Power loss during operation.
DESCRIPTION
Indicates the auger motor is turning and
feeding pellets to the burn pot.
Indicates the igniter is on. When first
starting your unit, the igniter runs
continuously for the start-up cycle.
Indicates the fan is running. If the grill is in
operation, the fan is on.
Indicates the auger motor is no longer able
to feed pellets to the burn pot. Likely, the
hopper is empty and requires refilling.