Understanding The Control Board - Pit Boss 10697 Assembly And Operation Manual

UNDERSTANDING THE CONTROL BOARD

MP1
FC
Actual
IGNITOR
300
250
350
PRIME
225
200
SMOKE
OFF HIGH
IGNITOR
250
PRIME
225
200
SMOKE
OFF
CONTROL
MP1
FC
Actual
IGNITOR
300
250
350
PRIME
225
200
475
SMOKE
OFF HIGH
Set
MP1
NO
PELLET
FC
Actual
F/C
Set
400
450
475
IGNITOR
MP1
FC
NO
PELLET
PRIME
Actual Set
225
NO
PELLET
200
300
350
F/C
SMOKE
400
450
475
HIGH
DESCRIPTION
The LCD Screen is used as the information center for
your unit. The LCD screen will display the current grill
temperature (ACTUAL) and meat probe temperature (MP1).
See Troubleshooting for more information on error codes.
Set
NO
PELLET
READOUT DESCRIPTION
F/C
Flashing Indicates the unit was just connected to
400
450
Screen AC power. Screen flashes three times, then
turns off.
MP1 Indicates the meat probe temperature
when probe is connected.
Actual Indicates the current temperature of unit.
Set Indicates the desired temperature that has
been selected.
noP Indicated that no meat probe is connected.
Er1 Grill Probe wire not connecting.
Er2 Failure to reach minimum temperature of
130F during start-up cycle.
Er3 Fire has gone out due to lack of fuel.
ErH Grill has overheated.
ErP Power loss during operation.
MP1
ID DESCRIPTION
FC
Motor Indicates the auger motor is turning and
feeding pellets to the Burn Pot.
Ignitor Indicates the igniter is on. When first
starting your unit, the igniter runs
continuously for the start-up cycle.
Fan Indicates the fan is running. If the grill is in
operation, the fan is on.
Actual
No Pellet Indicates the auger motor is no longer able
to feed pellets to the Burn Pot. Likely, the
IGNITOR
hopper is empty and requires refilling.
Press and hold the Prime Button to activate an extra feed of
300
250
pellets to the Burn Pot. This can be used to add more fuel to
350
the fire just before opening the barrel lid, resulting in a quicker
heat recovery time. It can also be used to add more fuel while
smoking, to increase the intensity of clean smoke flavor.
Overfeeding the Burn Pot may damage to grill barrel paint.
The Temperature Switch Button is used to change the
temperature readout on the LED Screen. Press the button
to switch to Fahrenheit (ºF) or to Celsius (ºC), as preferred.
Default is set to Fahrenheit.
OFF HIGH
Set
NO
PELLET
F/C
400
450
475
13