Mdp Status Bits - Emerson Rosemount 2410 Instruction Manual

Optional configuration and settings
August 2023
5.13

MDP status bits

In the Sakura MDP response, there are a number of status bits that can be manually
configured. These status bits can be customized by the expanded bitfield windows of
holding register Sakura _DisplConf (1215) and Sakura _StatusConf (1216). See
Figure 5-4: Sakura MDP Status Bits
Status bit 14 and 15 in holding register Sakura _DisplConf (1215) can be used to control the
use of the other status bits, see
Table 5-11: Holding Register Sakura_DisplConf 1215, BIt 14 and 15
Bit
14
15
32
Table
Name Default value
Use Nothing But 0x0
Hreg Status Bits
Indicate Valid 0x1
Level as Balance
5-11.
Description
By setting bit 14, the status bits will always be
sent as the status bits are set in holding register
1215 and 1216.
If bit 14 is not set, the status bits from holding
register 1215 and 1216 will still be used except
status bits C1, C2, P1, P2, P3, TC4_Bit0, TC4_Bit1,
TC4_Bit2 and TC4_Bit3. These bits will be set
according to the request and level status.
By setting bit 15, an invalid level value will
be indicated by status bits (P1, TC4_Bit2 and
TC4_Bit3). Note that bit 14 will override bit 15.
Manual Supplement
00809-0800-2410
Figure 5-4.
Emerson.com/Rosemount