Table of Contents
Advertisement
3 Installing your P10 components
3.1 Unpacking
The P10's cartons are large and contain both the components and all of their accessories. You will need an open,
preferably carpeted area in which to unpack them. Please also ensure that the rack or support space on which
the P10 will be placed has been cleared and cleaned before you start. At this point it is also worth ensuring that
the connectors on any interconnect cables are cleaned and that the power to your system is turned off. Each
carton consists of an inner box and outer sleeve. It is easiest to empty one box at a time, before reassembling it
to save space.
Once you open the inner box, remove the top layer of white foam packaging. Inside you will see the component
chassis and various accessories.
With a helper, carefully lift the P10 component out of the box and place it to one side. Then carefully remove the
plastic bag in which it is sealed.
Remove the small, brown Accessory Pack and place it with its unit. Also remove the power cord and suction cup
(if present) and the four, black, levelling/grounding spikes that are set into the foam.
We recommend storing the Accessory Packs in a readily accessible place, so don't put them back in the cartons
with the plastic bags when resealing them.
3.2 Package contents
Your P10 should arrive in two substantial cartons. Once unpacked these cartons and packaging materials
should be stored safely in case you ever need to transport your units. When moving or transporting the P10
units, this should always be done in the original packaging.
The audio chassis carton should contain:
The P10 Phono-stage
Four composite titanium/polymer spikes
A suction cup (used to remove the four top covers)
An accessory box containing:
–
an infrared remote control
–
a spike adjustment screwdriver
–
a Torx T-10 screwdriver
–
four support discs
–
four smaller, dimpled stacking caps
–
a USB stick containing the latest CH Precision firmware
P10 User Manual
9
Advertisement
Table of Contents
