Control Actions In Normal Mode; To Initiate Operate Or Standby; To Select An Input; To Engage Shortcuts (High Pass Filter, Eq Curves, Phase, Etc.) - CH P10 User Manual

6.1 Control actions in normal mode

In general use, the five front panel buttons can be used to switch the P10 from standby to operate, select inputs,
alter operating parameters, select short-cut functions or enter the Menu mode.
7
6
(1) Operating mode (in dual monaural) or handled
channel (in true monaural) or
(2) Indicates if output stage uses global feedback
(GLOBAL-FB) or local feedback (nothing is displayed
in this case).
(3) Absolute phase polarity indication. If the (H)
symbol is present, polarity is reversed.
(4) Mute or Mono. If the 7 present, the P10 output is
muted. A single dot in a square will indicate that the P10

6.2 To initiate operate or standby

Push the top button to turn the unit on from standby. Push it for three seconds (long push, "LP" in this manual)
to turn the P10 back to standby.

6.3 To select an input

Press the Up or Down buttons to cycle through the inputs.

6.4 To engage shortcuts (high pass filter, EQ curves, phase, etc.)

Short push on the Middle/OK button to cycle through shortcut options. Display will show selected shortcut
function: Use Up and Down buttons to alter parameter value. Note that the current input is automatically pre-
selected for all input-specific parameters that are configured through a shortcut.
1
STEREO GLOBAL-FB H
MM/MC 2
e-RIAA
Normal mode display elements
P10 User Manual
2 3 4
7
1.00 kU
is running in mono mode, summing L and R channels.
(5) Impedance setting for MM/MC inputs.
(6) Selected record replay EQ curve. Shows use
of Neumann pole (e- prefix) and selected curve if
optional curves are installed. Whole display also
changes color (auto or user selectable shades) to
indicate alternative curves.
(7) Input source name. Each input source can be
renamed through the P10's menu.
5
20