Setting Up Your P10; Safety Notice; Changing Fuses And Operating Voltage - CH P10 User Manual

2 Setting up your P10

2.1 Safety notice

Like any piece of sensitive audio electronics, there are certain precautions that you should take in handling and
installing your CH Precision P10 in order to protect yourself, your new equipment and your system.
Always handle with care. The P10 phono-stage components are heavy, so have someone to help you when
unpacking, re-packing or moving them around.
Install both chassis of your P10 phono-stage on strong, stable supports capable of holding their weight. It is
best to clear/prepare the supporting surfaces in advance.
Do not install your P10 phono-stage near water. Do not expose the units to any kind of liquid.
Do not install them under direct sunlight or near any heat source, such as a radiator or other apparatus
generating heat.
Do not install them in a confined space and make sure there is sufficient ventilation and airflow around and
beneath each unit.
Do not operate them under high ambient temperature (>40°C) or in extremely high humidity conditions
(>85%) such as humid cellars. Only use options and accessories specified or recommended by CH Precision.
Do not open the units or try to service them yourself. Always refer to a qualified technician for service,
maintenance or upgrades. Failure to do so will void the unit's warranty
In Denmark: Apparatets stikprop skal tilsluttes en stikkontakt med jord som giver forbindelse til stikproppens jord.
In Finland: Laite on liitettävä suojakoskettimilla varustettuun pistorasiaan.
In Norway: Apparatet må tilkoples jordet stikkontakt.
In Sweden: Apparaten skall anslutas till jordat uttag.

2.2 Changing fuses and operating voltage

To change the fuses, switch off the P10 and remove the power cable.
The fuse holder is located below the IEC power input on the Power Supply chassis.
See diagram on page 16 (Arrow 3)
Fuse values vary with operating voltage:
230VAC – Fuse A : T50mA/250Vac. Fuse B : T2.5A/250Vac
100/115VAC – Fuse A : T100mA/250Vac. Fuse B : T5A/250Vac
Never change the selectable voltage during operation.
To change operating voltage, switch off the P10 and remove
the power cable.
Before changing the operating voltage first check the local voltage.
B
P10 User Manual
A
6