Table of Contents
Advertisement
Installed options
Lists the hardware configuration of your P10, including whether the optional EQ boards are installed.
IR remote
Pair IR remote control: By default any P10 will respond to a command sent by any P10 remote control. In
some situations, this code can be identical to the one of another appliance. Pairing a specific remote control
with a specific P10 allows them to communicate on a private channel.
8 The CH-Control App
All CH Precision components can be controlled via an Android App loaded onto a compatible device
(SmartPhone or Tablet). In order to use the Control App, a unit must be hard-wired to a wireless network router
(although please note that the network does not need to be connected to the internet). The Control App gives
access to all aspects of unit set up (including gain, loading and input naming via a keyboard) from the listening
seat. It can be particularly useful during set up, even if you do not intend to use it as a permanent part of your
system. In this case it is easy to install a temporary network.
9 Handheld IR remote control
The P10 phono-stage is delivered with an infra-red remote to drive the unit's basic operational functions.
The provided remote control is not intended to be used to configure the unit. It can be magnetically attached to
the side panel of the P10 audio unit for storage
9.1 Batteries
If the Remote Activity LED fails to light then you will need to change the batteries in the handset.
The T-10 torx screws that hold the black bottom plate can be removed with the provided screwdriver.
The remote takes two AAA batteries.
1
P10 remote control
2
(1) Remote control activity LED
3
(2) Mute [NP] / Standby [LP] button
(3) EQ curve selection [NP] / High Pass Filter
[LP] button
4
(4) EQ curve selection [NP] / Neumann pole
selection [LP] button
5
(5) Absolute phase polarity inversion [NP] /
mono/stereo selection [LP] button
(6) Input selection [NP] / Local/global
6
feedback [LP] button
P10 User Manual
26
Advertisement
Table of Contents
