Display Settings Menu; Shortcut Menu - CH P10 User Manual

Filter
Set the High Pass Filter when required. The default setting for this parameter is full bandwidth, but engaging
the high-pass filter allows users to eliminate 'rumble' cut into some records, caused by eccentricity or
excessive warping. If present, these low-frequency distortions can erode sound quality, absorb output power
and in extreme cases, cause damage to loudspeakers. If excessive low-frequency 'rumble' is present, use the
high-pass filter to solve the problem.
Name
Select identity for source/cartridge connected using up to 12 letters or numerals (including spaces). Text is
entered using the Up, Down and Middle buttons. Scroll through the alpha/numeric listing until you have the
letter, number, spaceor punctuation required. Press the Middle button to save that selection and shift the
cursor to the next space. Don't forget to save the name with the Middle button when complete. Alternatively,
you may want to rename your P10 inputs directly from the keyboard of the CH Control App.
Gain Wizard
Run the Gain Wizard to set a gain value providing the best signal-to-noise ratio (any input)..
Loading Wizard
Run the Loading Wizard to optimize impedance load setting for voltage mode inputs (MM/MC 1 or 2).

7.4 Display settings menu

Display mode
Allows the user to change display brightness and whether or not the display remains on or switches off after
a short time.
Front LED
Allows the user to turn the red power LED off when the units are active rather than in standby.
Display brightness and gamma
Allows you to set the brightness of the display in operating mode (10 – 100%), and to fine tune the high
brightness gamma curves to perfectly match the brightness and color of other displays.
Display brightness (dimmed)
Allows you to set the brightness of the display when dimmed between operations (10 – 30%), and to fine tune
the low brightness gamma curves to perfectly match the brightness and color or other displays.
Display color
Lets the user select the display color from one of seven standard colors, or set their own RGB defined color.
If the optional EQ curves are fitted, the display will automatically change color to reflect the different curves.
The factory-defined color for each curve was selected to reflect the color of the record label in question
(where possible) but can be user adjusted to suit personal preference.

7.5 Shortcut menu

The P10 allows you to establish up to six shortcuts, taking you directly to almost any parameter in any menu.
The P10 is preprogrammed with the High Pass Filter and EQ curves (if available) as shortcuts one and two. After
scrolling through the defined shortcuts (you can set a total of six different shortcuts), the next screen that the
P10 displays is the entry port to the P10 menu, titled Detailed Setup.
P10 User Manual 24