Network Menu; Factory Settings Menu - CH P10 User Manual

7.6 Network menu

Status
Shows a list of compatible devices detected on the LAN.
Role
When physically connected to a network, the P10 can ignore this network (offline) or connect to it as either
the master unit (it will transmit push-button commands to all compatible client units) or as a client (it will
ignore push-button entries and receive commands only from the master device). This networking facility
allows system-wide sharing of commands among CH products (such as mute or power up/down).
Room number
Defines the room in which the P10 is located for multi-room applications.
This prevents CH Precision units connected to the same network but located in different systems/rooms from
interacting with each other.
IP settings
Auto should be selected if the P10 is connected to a router with a DHCP server feature.
Direct-Link should be selected when an RJ45 Mirror lead directly connects a Master P10 to a Client P10 in
four-box configuration. More advanced settings are available if needed.
Wake-on-LAN
If 'No' is selected, the P10 cannot be switched on from the CH-Control App.
If 'Only If PoE' is selected, connecting the P10 to a Power Over Ethernet switch will allow it to be switched on
via the CH-Control App (Standby consumption will be less than 0.5W).
If 'Yes' is selected, the P10 can always be switched on by the CH-Control App (Standby consumption will be
less than 2W).
Power off command
If Yes is selected, the P10 will enter standby mode when it receives a Power Off command from the LAN. It
will remain on if No is selected. This is useful if you want to keep your P10 on even when you turn off the rest
of your system.

7.7 Factory settings menu

Serial Number
Displays the serial number of your P10. This serial number is also written on a sticker at the back of your P10.
Firmware version
Indicates the version of the firmware that the P10 is currently running. Periodically check CH Precision's
website to see if a newer version is available. It could add new features or correct bugs.
Note that the CH Control App will inform you of updates, indicating that a device is not up to date by
displaying its name in orange instead of red.
Update firmware
Selecting Update launches the P10 firmware update process. A USB flash disc drive with a valid set of
firmware must be inserted in the USB-A port. Please refer to the corresponding section of this manual for
more detail on the firmware update procedure.
Factory reset
Resets all parameters to their default factory values. This can be useful if you have made some changes
that you don't know how to revert. Note that it is also possible to reset small subsets of parameters to their
default values from other locations in the menu tree.
P10 User Manual 25