6.2. Example: LinPAC (Linux OS)
User can use the Linux command "wvdial" to connect the network via
i-8213W-4G's port "ttyUSB3".
Step 1: Enter the command
"cat
/etc/wvdial.conf" to modify the ISR's
wvdial.conf file, set the ISP's network configuration and save it, refer to
the following example
Step 2:Enter the command
"wvdial
&" to enable 2G/3G/4G.
Step 3: After checking the IP address provided by the network provider,
see if the "ppp0" network interface is active.
I-8213W-4G Series User Manual
version 1.3
Page:36
Copyright © 2017 ICP DAS Co., Ltd. All Rights Reserved. E-mail:service@icpdas.com