Remote Control; Placing/Replacing The Batteries - Dru Virtuo 100 Evolve User Manual

4.2 Remote control

The appliance is supplied with a remote control. Its functions
and possibilities are described in the following subsections.
The symbol on the display of the remote control shows the current
2
status of the connection with the appliance:
- Not visible: No connection with the appliance
- Flashing: Looking for connection with the appliance
- Visible: Connected with the appliance

4.2.1 Placing/replacing the batteries

The remote control works with two AA alkaline batteries.
When the
be replaced.
- It is not possible to use rechargeable batteries.
2
- If the batteries are completely empty, the display will go blank.
Replace the batteries of the remote control in time. Timely replacement
of the batteries also prevents possible damage to the electronic
components due to leaking batteries.
Place and replace the batteries as follows:
Remove the cover from the battery compartment by pushing it down
1
lightly and sliding it off the remote control (fig. 4-1, 1).
Remove the old batteries from the holder (fig. 4-1, 2).
1
Place the new batteries in the holder (fig. 4-1, 2).
1
The correct orientation of the batteries to be placed is shown on the inside
2
of the battery compartment.
Place back the cover, slide it upwards and allow it to snap tight to lock
1
(fig. 4-1, 3).
Hand in the batteries at the collection point intended for this purpose.
3
User manual
symbol lights up on the display, the batteries should
14