Summary of Contents for Moxa Technologies DRP Series
Page 1
DRP Series Quick Installation Guide Version 1.0, September 2023 Technical Support Contact Information www.moxa.com/support 2023 Moxa Inc. All rights reserved. P/N: 1802001004010 *1802001004010*...
Warranty card NOTE Please notify your sales representative if any of the above items are missing or damaged. Panel Layouts The panel layouts of the DRP series computers are shown in the following illustrations: DRP-C100-C1-T/DRP-C100-C5-T/DRP-C100-C7-T Models Front View - 2 -...
Page 3
Top View Bottom View DRP-C100-C1-8L-T/DRP-C100-C5-8L-T/DRP-C100-C7-8L-T Models Front View Top View Bottom View - 3 -...
Page 4
DRP-C100-C1-6C-T/DRP-C100-C5-6C-T/DRP-C100-C7-6C-T Models Front View Top View Bottom View - 4 -...
Page 5
DRP-C100-C1-2L4C-T/DRP-C100-C5-2L4C-T/DRP-C100-C7-2L4C-T Models Front View Top View Bottom View - 5 -...
Page 6
DRP-A100-E2-T/DRP-A100-E4-T Models Front View Top View Bottom View - 6 -...
Page 7
DRP-A100-E2-8L-T/DRP-A100-E4-8L-T Models Front View Top View Bottom View - 7 -...
Page 8
DRP-A100-E2-6C-T/DRP-A100-E4-6C-T Models Front View Top View Bottom View - 8 -...
Page 9
DRP-A100-E2-2L4C-T/DRP-A100-E4-2L4C-T Models Front View Top View Bottom View - 9 -...
LED Indicators The following table describes the LED indicators located on the front panel of the DRP Series: LED Name Status Function Power Green Power is ON No power input or any other power error Ethernet Green Steady ON: 10/100 Mbps Ethernet link...
Page 13
STEP 1: Pull down the latch on the mounting kit with a screwdriver. STEP 2 & 3: Slightly pull the DRP Series forward and lift it up to remove it from the DIN rail. The specifications of the DIN-rail mounting screws are indicated in the illustration on the right.
Page 14
ATTENTION This product is intended to be supplied by a Listed Power Supply with output marked LPS and rated to deliver the following power specifications: DRP-C100:12 VDC (max.) @ 6.82A, 24 VDC (max.) @ 3.25A DRP-A100: 12 VDC (max.) @ 5A, 24 VDC (max.) @ 2.5A and a minimum Tma=60˚C.
– USB Hosts The DRP Series has 3 USB 3.0 Type-A connectors located on the front panel. The ports support keyboard and mouse devices and can also be used to connect a flash disk for storing large amounts of data.
Page 16
2. Remove the cover and find the location of the SD and CFast card slots. 3. Insert the SD and CFast cards in the designated slots. Refer to the image printed beside the slots for the correct direction to insert the cards. When the cards are successfully inserted, you will hear a click.
Page 17
5. Place a new battery in the battery holder, replace the metal plate, and fasten the two screws on to the frame to secure the battery. 6. Plug in the connector of the battery-cover assembly to the internal wire of the slot. 7.
Need help?
Do you have a question about the DRP Series and is the answer not in the manual?
Questions and answers