Installation - netvox R718N1 E Series User Manual

6. Installation

1. The single-phase current meter R718N1xxx(E) series
has a built-in magnet (see Figure 1 below). It can be
attached to the surface of an object with iron during
installation, which is convenient and quick.
To make the installation more secure, please use screws
(purchased separately) to fix the device to the wall or
other objects (such as the installation diagram).
Note: Do not install the device in a metal-shielded box or
in an environment surrounded by other electrical
equipment to avoid affecting the wireless
transmission of the device.
4. The single-phase current meter samples the current
according to MinTime. If the current value sampled this time
relatively exceeds the set value (the default is 100mA) more
than the current value reported last time, the device will
immediately report the current value sampled this time. If
the current variation does not exceed the default value, the
data will be reported regularly according to MaxTime.
5. Press the function key of the device to start sampling
data and report the data after 15 seconds.
Note: MinTime cannot be less than 30 seconds.
MaxTime must be set greater than Min Time.
2. Open the clamp-on current transformer, and then pass the
live wire through the current transformer according to the
installation.
Note: "L←K" is marked on the bottom of the CT.
3. Precautions:
3.1 Before using, users must check whether the appearance
is deformed; otherwise, the test accuracy will be
affected.
3.2 The using environment should be kept away from strong
magnetic fields, so as not to affect the test accuracy. It is
strictly forbidden to use in humid and corrosive gas
environments.
3.3 Before installation, please confirm the current value of
the load. If the current value of the load is higher than
the measurement range, select a model with a higher
measurement range.
The single-phase current detector R718N1xxx(E) is suitable
for the following scenarios:
⚫ School
⚫ Factory
⚫ Shopping mall
⚫ Office building
⚫ Smart building
Where the electrical data of the device with the single-phase
electricity needs to be detected.
12