Table of Content 1.Introduction ..................................2 2.Appearance ..................................3 3.Main Features ..................................3 4.Set up Instruction ................................4 5.Data Report ..................................5 5.1 Example of ReportDataCmd ............................5 5.2 Example of ConfigureCmd ............................6 5.3 Example for MinTime/MaxTime logic ........................7 6.Information about Battery Passivation ..........................
1. Introduction R718KA is a current detection device for Netvox Class A type devices based on LoRaWAN open protocol. The device is suitable for detecting 4mA to 20mA current, and R718KA is compatible with LoRaWAN protocol. LoRa Wireless Technology: LoRa is a wireless communication technology famous for its long-distance transmission and low power consumption. Compared with other communication methods, LoRa spread spectrum modulation technique greatly extend the communication distance.
Applicable to third-party platforms: Actility/ThingPark, TTN, MyDevices/Cayenne Low power consumption and long battery life Battery Life: ⁻ Please refer to web: http://www.netvox.com.tw/electric/electric_calc.html ⁻ At this website, users can find battery life time for variety models at different configurations.
4. Set up Instruction On/Off Power on Insert batteries. (users may need a screwdriver to open) Turn on Press and hold the function key for 3 seconds till the green indicator flashes once. Turn off (Restore to factory setting) Press and hold the function key for 5 seconds till green indicator flashes 20 times. Power off Remove Batteries.
1. The cycle of the device sending the data report is according to the default. 2. The interval between two reports must be the MinTime Please refer Netvox LoRaWAN Application Command document and Netvox Lora Command Resolver http://www.netvox.com.cn:8888/page/index to resolve uplink data.
Page 9
MaxTime Sleeping(MinTime) sleeping sleeping sleeping Wakes up and Wakes up and Wakes up and Wakes up and collects data collects data collects data collects data REPORT 3.6V 3.6V 3.6V REPORT 3.6V Does not report Does not report Example#3 based on MinTime = 15 Minutes, MaxTime= 1 Hour, Reportable Change i.e. BatteryVoltageChange= 0.1V MaxTime Wakes up and collects Users push the button,...
6.Information about Battery Passivation Many of Netvox devices are powered by 3.6V ER14505 Li-SOCl2 (lithium-thionyl chloride) batteries that offer many advantages including low self-discharge rate and high energy density. However, primary lithium batteries like Li-SOCl2 batteries will form a passivation layer as a reaction between the lithium anode and thionyl chloride if they are in storage for a long time or if the storage temperature is too high.
7. Important Maintenance Instruction Kindly pay attention to the following in order to achieve the best maintenance of the product: • Keep the device dry. Rain, moisture and various liquids or water may contain minerals that can corrode electronic circuits. In case the device is wet, please dry it completely.