Table of Contents
Advertisement
6. Installation
This product comes with waterproof function.
When using it, the back of it can be adsorbed on the iron surface, or the two ends can be fixed to the wall with screws.
When installing the current transformer, separate the fire and neutral wires, and take out the fire wire separately and start the measurement according to
the wiring below.
Note:
Please do not disassemble the device unless it is required to replace the batteries.
Do not touch the waterproof gasket, LED indicator light, function keys when replacing the batteries. Please use suitable
screwdriver to tighten the screws (if using an electric screwdriver, it is recommended to set the torque as 4kgf) to ensure the
device is impermeable.
8
Advertisement
Table of Contents
