Related Manuals for netvox R718PA22
Summary of Contents for netvox R718PA22
- Page 1 Model：R718PA22 Ultrasonic Fuel Level Meter Ultrasonic Fuel Level Meter User manual...
-
Page 2: Table Of Contents
Table of Content 1. Statement....................................................2 2. Appearance..................................................2 3. Introduction..................................................2 4. Main Characteristics................................................2 5. Operation....................................................3 6. Installation.....................................................6 7. Important Maintenance Instruction..........................................7... -
Page 3: Statement
Netvox follows a strategy of continuous development. Therefore, Netvox reserves the right to make changes and improvements to any of the products described in this document without prior notice. Under no circumstances will Netvox be liable for any loss of data or income, or for any special, incidental, incidental or consequential damages, regardless of the cause of the loss. -
Page 4: Operation
Compatible with LoRaWAN Class A Frequency hopping spread spectrum technology Configuration parameters can be configured through third-party software platforms Data can be read and alerts can be set via SMS text and email (optional) Applicable to third-party platforms: Actility / ThingPark / TTN / MyDevices / Cayenne 5. - Page 5 Note: The data transmission period of the device has been programmed. The interval between two reports must be the minimum time The data report can be decoded by the Netvox LoraWAN Application Command document and http://www.netvox.com.cn:8888/page/index Data report configuration and sending period are as following:...
- Page 6 FPort：0x07 Measuretype（1byte， Reserved (8Bytes,Fixed 0x00) SetMeasu 0x01_water, reTypeRe 0x03 0x02_gasoline, 0x03_diesel oil） SetMeasu Status(0x00_success) reTypeRs 0x83 Reserved (8Bytes,Fixed 0x00) R718PA22 0x9B GetMeas Reserved (9Bytes,Fixed 0x00) ureTypeR 0x04 Measuretype（1byte， Reserved (8Bytes,Fixed 0x00) GetMeas 0x01_water, ureTypeR 0x84 0x02_gasoline, 0x03_diesel oil） (1) Configure device sampling type: 01 = WATER, 02 = GASOLINE, 03 = DIESEL_OIL...
-
Page 7: Installation
Example#3 based on MinTime = 15 Minutes, MaxTime= 1 Hour, Reportable Change i.e. BatteryVoltageChange= 0.1V. Wakes MaxTime Users push the button, Wakes up and collects data and collects REPORTS 3.5V. data 3.5V |3.5-3.6|=0.1 Wakes Recalculate MaxTime. REPORTS 3.5V REPORTS collects data 3.5V 3.5V sleeping... - Page 8 Install the sensor at the bottom of the container / tank: 1. Power on first to see if the sensor is working normally. The red light flashing on the sensor indicates that the sensor can work normally, as shown in the figure.
-
Page 9: Important Maintenance Instruction
7. Important Maintenance Instruction Your device is a product of superior design and craftsmanship and should be used with care. The following suggestions will help you use the warranty service effectively. • Keep the equipment dry. Rain, moisture, and various liquids or moisture may contain minerals that can corrode electronic circuits. In case the device is wet, please dry it completely.