Planing Short Workpieces; Planing The Workpiece With Small Cross Section; Thicknessing; Converting From Planer To Thicknessing - HOLZMANN MASCHINEN HOB260MINI-230V Operating Manual

15.6.3

Planing short workpieces

15.6.4

Planing the workpiece with small cross section

15.7

Thicknessing

It is necessary to modify/adjust the machine before using as a thicknesser.
Long, protruding workpieces must be sufficiently supported! Use suitable aids such as roller
•
blocks etc. for this purpose. If you do not follow these instructions, there is a danger of the
workpiece being raised up quickly and/or the machine being tilted!
Use the thicknessing function only to reduce the thickness of a workpiece with an already
•
surface planed facing!
For workpieces with a difference in thickness, the chip removal must be measured at the
•
maximum thickness and the workpiece machined with this side first.
Make sure that the workpiece to be machined is free of foreign objects and/or knots in
•
order to avoid dangerous fractures.
Only plane workpieces that rest firmly on the machine and can be guided safely!
•
If several workpieces are to be processed in series, all pieces of the same thickness should
•
be run through in succession without changing the setting.
• Perform the machining process from the beginning until the desired thickness is achieved.
15.7.1

Converting from planer to thicknessing

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
• When planing short workpieces, a sliding wood or similar
device should be used!
• Adjust planer fence and blade guard to the size of the
sliding wood.
• Place the workpiece on top and push it slowly and evenly
over the shaft using the sliding wood.
• After use, the sliding wood must be reattached on his place
on the side of the machine.
• When planing workpieces with a small cross-section, an
additional wood angle must be mounted!
• Fasten the wood angle to the planer fence as shown using
lever clamps.
• When planing, place the workpiece on the planer table and
press it against the additional wood angle and planer table.
• Place the workpiece on top and push it slowly and evenly
over the shaft using the sliding wood.
N O TE
• Slide the planer fence (4) all the way to the back and
fix it or disassemble the planer fence.
• Disassemble the hose of the dust collector plug.
• Unlock the clamping levers exit planer table (4)
• Remove the exit planer table
• Swing the chip chute (1) up over the planer shaft
• Turn in the safety screw (6) to the end position
NOTE: Only than the limit switch will be activated and
the machine can be switched on!
• Fix the dust collector hood (2) with the knurled nut
(3) on the chip chute
• Mount hose to the dust collector plug again.
Proceed in reverse order to readjust to the planer
mode.
OPERATION
36
HOB260MINI_230V