Operation; Initial Check Before Start; Starting The Machine; Stopping The Machine - HOLZMANN MASCHINEN EHH110 Operating Manual

OPERATION

13.1 Initial check before start

• Check that all guards are installed.
• Check whether suitable planing knives have been correctly assembled.
• Check whether the connection to a dust collection system is available.
13.2 Operation

13.2.1 Starting the machine

Press the lock off button (a) and then press the on/off switch (b)
and hold it.

13.2.2 Stopping the machine

Release the ON/OFF (b) to stop the machine.

13.2.3 Adjust depth of cut

The depth of cut can be easily adjusted by rotary knob (1).
The selected depth can be read off the scale (2).
13.3

Operation instructions

13.3.1 Planing

13.3.2 Rebate cuts

2
1
HOLZMANN MASCHINEN GmbH
1. First, place the front base of the machine (pick-up
2. Switch on and wait until the planing shaft has
3. Then carefully move the machine forward. Apply
NOTE:
stationary, so that you can plan downhill a bit. The cutting
speed and depth determine the quality of machining. The
machine cuts at a speed that does not cause chips to jam. For
rough cutting, the cutting depth can be increased, while for a
good finish you should reduce the cutting depth and move the
tool forward more slowly.
Use the rip-fence to perform rebate cuts as shown in the
figure.
1. Draw a cutting line (2) on the workpiece. Insert
2. When planing, move the machine along the
www.holzmann-maschinen.at
table = movable table) flat on the workpiece. Take
care that blades are not in contact with the
workpiece.
reached full speed.
pressure to the front of the machine at the
beginning of planing and to the back at the end of
planing. .
Planing will be easier if you tilt the workpiece
the stop into the hole at the front of the tool.
Align the blade edge (1) with the cutting line and
adapt the stop using the screws. The max.
rebate width is limited to 110mm.
workpiece flush with the stop. Otherwise the
result will be uneven.
23
EHH110