Elektrischer Schaltplan / Wiring Diagram - HOLZMANN MASCHINEN HOB260MINI-230V Operating Manual

Workpiece clamps during
thicknessing
Bad surface condition
after operating
Rough surface after
operating
Cracked surface after
operating

ELEKTRISCHER SCHALTPLAN / WIRING DIAGRAM

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
ELEKTRISCHER SCHALTPLAN / WIRING DIAGRAM
 Cutting depth to high
 Dirty thicknessing table
 Blunt blade
 Uneven feed of the workpiece
 Workpiece too moist
 Workpiece was processed against
the direction of growth
 Cutting depth to high
Set the correct cutting

depth and operate in
more steps
Clean and apply the table

surface with lubricant
Check blade

Feed workpiece evenly

and with constant
pressure
Use drier workpiece

Proceed the workpiece in

opposite direction
Set the correct cutting

depth and operate in
more steps
HOB260MINI_230V
41