Thicknessing Of Workpieces; After Working Process; Cleaning, Maintenance, Storage, Disposal - HOLZMANN MASCHINEN HOB260MINI-230V Operating Manual

For readjusting to planer mode please lower the thicknesser table at least to lowest
position to avoid any damages.
15.7.2

Thicknessing of workpieces

In the case of resin residues on the wood, it may be advisable to apply a thin
•
layer of a special lubricant to the machine table in order to ensure that the
workpiece slides evenly through the thickness planer.
• If the workpiece is no longer moved by the automatic feed, pull out the
workpiece manually.
• After operation switch off the machine.
Before further activities wait until blade shaft is at a standstill!
•
15.8

After working process

After the working process the planer and thicknesser must be turned off:
Switch off the machine and disconnect the machine from the power supply.
•
Adjust the planer knife cover so that the planer shaft is completely covered
•

CLEANING, MAINTENANCE, STORAGE, DISPOSAL

Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
 Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O TE
• Set the thicknessing table height to the workpiece
height minus the requested cutting depth using the
hand crank height adjustment thicknesser.
• The height will be shown on the scale.
NOTE: The height is adjusted by 3 mm per crank turn
• Maximum cutting depth refer to the technical data!
NOTE: At the beginning of the thicknessing process, the
workpieces may still have very different thicknesses - this
must be taken into account in the set cutting depth in
order not to overload the machine.
• Switch on the machine.
working direction
• Insert workpiece so that the surface to be machined facing
upwards and push forward
• The workpiece is pulled through of the automatic feed
• As soon as the half of the workpiece has been processed change to
the opposite operator side of the machine and take on the finished
workpiece.
• After operation switch off the machine.
• Before further activities wait until blade shaft is at a standstill!
N O TE
N O TE
WAR N I N G
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
37
HOB260MINI_230V