Connecting To A Dust Collection System; Operation; Operating Instructions; Initial Check Before Start - HOLZMANN MASCHINEN HOB260MINI-230V Operating Manual

Use a supply cable that fulfils the electrical requirements (e.g. H07RN, H05RN) and take the
•
required cross-section of the supply cable from a current carrying capacity table. Pay
attention to the measures for protection against mechanical damage.
Make sure that the power supply is protected by a residual current circuit breaker.
•
Connect the device only to a properly grounded outlet.
•
• When using an extension cable, make sure that the dimension matches the connected
load of the machine. The connection power can be found in the technical data, the
correlation of cable cross-section and cable lengths can be found in the technical literature
or obtain information from a specialist electrician.
A damaged cable must be replaced immediately.
•
14.6

Connecting to a dust collection system

The machine must be connected to a dust collection system for dust and chips. The dust collection
system must start up at the same time as the machine's engine. The air speed at the suction
connection and in the exhaust air lines must be at least 20 m/s for materials with a moisture <12 %
(at least 28 m/s for moist chips with a moisture >12 %). The hoses used must be flame-retardant
(DIN4102 B1) and permanently antistatic (or earthed on both sides) and comply with the relevant
safety regulations. For information on air volume flow, negative pressure and suction connection,
please refer to the technical specifications.

OPERATION

15.1

Operating instructions

Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
 Always disconnect the machine from the power supply before carrying out any
modification and secure it against unintentional reconnection.
Never start the machine with a workpiece pressed down!
•
Long workpieces must be supported
•
Property damage and injury by bouncing up the workpiece or tilting of the
•
machine possible!
15.2

Initial check before start

Check that all guards are installed.
•
Check whether suitable planing knives have been correctly assembled.
•
• Check whether the connection to a dust collection system is available.
Check that the planer shafts rotate in the correct direction.
•
15.3

Settings

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
WAR N I N G
CAUTION
1. Height adjustment of the planer table
Entry planer table
The cutting depth is set by turning the adjustment
knob planer cutting depth (1)
Check scale knife entry planer table = 0
If necessary, adjust the arrow of the scale (2)
OPERATION
33
HOB260MINI_230V