Table of Contents
Advertisement
Network Setting
The default IP address is 192.168.0.10. You can reset the IP address and network settings based on
your IP address segment. Click Save to save the new Settings. After setting the parameters, please
restart the system to apply the changes.
By default, the Redirect option is disable. In this case, PDUs support http or https. If this option is
enable, PDUs can only support https access.
By default, the smart DHCP option is disable. In this case, you need to set the IP address of the PDU. If
this option is enable, the PDU changes to dynamic IP address assignment mode.
You can restart the PDU in two ways:
1. Press the embedded RST reset button at the front of the PDU with a needle, such as the
end of a paper clip, to restart the PDU.
2. On the Web page of the PDU, select the Upgrade option in Global Setting and click
Restart to restart the device.
IP-based 8-port Switched Power Manager with 2 Cascaded Ports
Figure 4-3-9 Network Setting Page Screenshot
31
-
-
IPM-8221
Advertisement
Table of Contents
