Technical Description; Installation - Dometic Oceanair Rollerblind Powered Installation And Operating Manual

Technical description

7 Technical description
Blinds are available in three mounting types in different sizes:
• BR: Bracket mounted (available in sizes BR38, BR46 and BR55)
• MP: Mounting profile mounted (available in sizes MP38 and MP46)
• CA: Cassette mounted (available in sizes C1, C2 and C3)
There are three different types of fabric restraints:
• FH: Free hanging
• GW: Guide wired (available as Dome (A), Flush Mount (B) and Extended (C), see
GW versions in fig. 1)
• ST: Side tracked (available with ST7, ST8, ST10 and ST11, see ST versions in
fig. 1)
The number on the product label indicating the blind type is located:
• For BR versions on the tube under the fabric
• For MP versions on the back of the mounting profile
• For CA versions on the back of the cassette
The blinds can be powered by 12 Vg, 24 Vg or 230 Vw.
The operating voltage requirement of the blind motor is specified on the label
attached to the cable.
8

Installation

The electrical power supply must be connected by a qualified electrician
who has demonstrated skill and knowledge related to the construction
and operation of electrical equipment and installations, and who is famil-
iar with the applicable regulations of the country in which the equipment
is to be installed and/or used, and has received safety training to identify
and avoid the hazards involved.
!
WARNING! Electrocution hazard
Disconnect the power supply before installation.
!
CAUTION! Risk of injury
Important safety instructions. Follow all instructions since incorrect
installation can lead to severe injury.
8
Rollerblind Powered
EN