Operation; Cleaning And Maintenance - Dometic Oceanair Rollerblind Powered Installation And Operating Manual

Rollerblind Powered
8.9 Connecting to an AP Remote control (optional)
I
NOTE
The button for setting up the remote control is located as shown:
• BR leaflet: fig. f
• MP leaflet: fig. b
• CA leaflet: fig. b
➤ Refer to the AP Remote control manual for further instructions.
9

Operation

!
CAUTION! Risk of injury
Only for boats and yachts: If the blind is in front of an open window,
then the blind should be stowed when driving at more than 10 knots or
in a sea state of more than moderate, as this can cause damage to the
blind. Parts that come loose may injure persons in the vicinity.
I
NOTE
The motors have a built-in, self resetting thermal cut-out for safety rea-
sons. Prolonged use or over loading the blind could trigger the cut-out.
If this happens allow the motor to cool for up to half an hour.
Observe the following notes:
• Each blind can be stopped in any position.
• When operating the blind with an automation system, operation depends on the
programming of the controls.
• The blind is set up in the factory to automatically stop:
– When the blind is fully deployed
– When the blind is fully stowed
10

Cleaning and maintenance

!
WARNING! Risk of injury
Take appropriate organizational measures for preventing operation of
the blind when maintenance, such as window or wall cleaning, is being
carried out in the vicinity, for blinds, which can be operated from a posi-
tion without the blind in view.
EN
Operation
13