Advertisement
Attach the left and right Pivot Brackets to the Desk Packers. Ensure the curved bottom
1.
edge of the Pivot Bracket is facing the inside of the wall bed. See Drawing #3. The
pivot point (standoff) must face outward to allow the Leg to line up with the vertical
edge of the Panel.
Wall Bed End Panel
25m
m
1.
Place the previously assembled Desk on the floor where it will be located when it is in use.
Hand tighten the Bolts to join the Desk Top to the Legs. DO NOT over tighten as the Legs
2.
needs to be detached later to attach the Desk to the Bed Face. (Drawing #4).
Cabinet
©2023 WallBeds Australia V1.9
STEP 2: Install Pivot Brackets
Drawing #3: Pivot Brackets
Desk Packer
The Pivot Brackets will be set at
approximately 25mm from the
front edge of the wall bed End
Panel.
STEP 3: Attach Desk Top to Desk Legs
Drawing #4: Desk on floor (Side View)
Pivot
Bracket
Wall Bed End Panel
Leg
Desk Top
7
Advertisement
