Power Cords - HPE Aruba Networking 2930M Start Here Manual

1 Port LEDs:
Off after self-test unless a network cable is connected and the
port is receiving link beat.
2 Speed Mode Selected LED:
Off after self-test in default configuration.
3 PoE Mode Selected LED (Only on HPE Aruba Networking 2930M
models that support PoE+ operation):
Off after self-test in default configuration.
4 User Mode Selected LED:
Off after self-test in default configuration.
5 Back Status LED:
Green after self-test if all modular components installed on the
back of the unit are functioning correctly. Slow flash orange if a
module on the back of the unit is in a fault state.
6 UID LED:
Locator or Unit Identification LED. Off after self-test.
7 Global Status LED:
Green after self-test in default configuration.
4. Remove the power cord from the switch and from the power source.

Power Cords

HPE Aruba Networking includes the power cord intended for use with your HPE Aruba Networking
switch. Different countries/regions may require different power cords. For a list of the power cords that
apply to your HPE Aruba Networking 2930M switch, see the section that lists power cords in the latest
edition of the HPE Aruba Networking 2930M Switch Series Installation and Getting Started Guide.
Start Here: Installation, Safety, and Regulatory Information 7