Connecting Power Cords; Verifying The Installation - HPE Networking Comware 5960 Switch Series Installation Manual

Connecting power cords

WARNING!
• Make sure each power cord has a separate circuit breaker.
• Before you connect a power cord, make sure the circuit breaker for the power cord is switched
off.
To connect the AC power cord for an HPE NW CW 5960 400G 1600W AC PSU
1. Insert the female connector of the AC power cord supplied with the power supply into the power
receptacle on the power supply.
2.
Use a releasable cable tie to secure the power cord to the handle of the power supply, as shown
in Figure2-23.
3.
Connect the other end of the power cord to an AC power source.
Figure2-23 Connecting the AC power cord for an HPE 5960 400G 1600W AC power supply
(R9Y18A)
(1) Releasable cable tie
(2) Lock the cable tie to secure the power cord to the handle of the power supply

Verifying the installation

After you complete the installation, verify the following items:
There is enough space around the switch for heat dissipation.
•
• The rack is sturdy and stable.
The grounding cable is securely connected.
•
The power supplies are as required by the switch.
•
• The power cords are correctly connected.
All the interface cables are cabled indoors. If any cable is routed outdoors, verify that the socket
•
strip with lightning protection has been correctly connected.
19