Table of Contents
Advertisement
TO REPLACE COVER:
A. Replace cover by fitting the cover over the top of the restraint first, then the sides of the child restraint,
and then fit around the rim of the restraint. Feeding through the harness adjuster button and crotch
strap. (If fitted with SICT™ - clip the plastic flaps in slots of air cushion, on either side of restraint).
B. Replace the elastic loops behind the restraint and at the front of the restraint underneath the stabilising
bar.
C. Lift the headrest to the highest position. Fit the headrest cover over the headrest and feed the harness
through the open slots in cover, ensure elastic or clip is attached at the rear of the headrest. Clip in
press studs to the headrest cover and clip in stud to seat shell.
D. Refit any Flexi / Infant Safety Cushion™ see page 83, shoulder pads and Ezy Buckle System as
required. See page 84 for suitability.
E. Ensure none of the harness straps are twisted.
ONLY USE BRITAX SAFE-N-SOUND SEAT COVERS THAT ARE DESIGNED AND TESTED
FOR USE WITH THIS PRODUCT.
VERY IMPORTANT :
Only replace the cover with Britax Safe-n-Sound
supplied replacement cover with identical shoulder
height markers or a replacement cover meeting
AS/NZS 8005.
CARE & MAINTENANCE
Instructions for Installation & Use
83
Advertisement
Table of Contents
