Table of Contents
Advertisement
HOW TO INSTALL USING ISOFLEX™ CONNECTORS
INSTALLING INTO THE CAR USING ISOFLEX™ AND TOP
TETHER
To prevent damage to vehicle seat it may be necessary to remove or
open a trim covering the ISOFIX low anchorages.
A. Locate the ISOFIX Lower Anchorages in the vehicle seat bight.
The location may be identified by one of the following symbols, or
the anchorage bars may be visible.
If you cannot locate them, check your vehicle owners manual.
B. With the restraint upright, remove both ISOFLEX™ connectors
from storage location on the rear of the restraint by lifting the
cover flap the clip as shown. Close the cover flaps.
64
Instructions for Installation & Use
ISOFIX lower anchorages in
the vehicle seat
C
Advertisement
Table of Contents
