Table of Contents
Advertisement
HOW TO USE
The shoulder straps must be in the slots which are
nearest to the child's shoulders, but not lower than the
child's shoulders.
There is only one set of slots. The slots move with the
headrest, therefore the headrest position must always
be checked and adjusted to the correct position.
When positioning baby into the restraint make sure
baby's back is fully supported onto the flat section and
the baby's nappy area (bottom) is resting in the bottom
curvature as shown. It is recommended that bulky
nappies are not used when baby is travelling in the
restraint as they can cause incorrect positioning of the
baby's back in the restraint.
There are 2 types of padded inserts, the Flexi Infant Safety Cushion™ and the Infant Safety Cushion™,
see page 83 for more information of use.
Use the Infant Safety Cushion™ when rearward facing for smaller babies until their shoulders reach the
lower shoulder height marker. Remove the cushion to create more room. Remain rearward facing until the
child reaches the lower shoulder height marker again.
The Flexi Infant Safety Cushion™ with wings removed may be used for rearward facing or forward facing
installation until the middle shoulder height marker is reached.
Discontinue the use of either padded insert, if there is insufficient room for the child, or their shoulders
reach the respective shoulder height marker.
44
Instructions for Installation & Use
SHOULDER STRAP POSITION
Flat section of
child restraint
Bottom curvature of child restraint
Advertisement
Table of Contents
